Mill Creek · ice
Ice Maker Repair in Mill Creek, WA
Bin empty in a Mill Creek kitchen? We check the water line, the filter and the ice maker, then fix the part at fault.
- Repair cost in writing up front
- LG and Whirlpool authorization
- Open all week, 8 AM–7 PM, Saturday and Sunday included

Kenmore side-by-side
Snapshot 1 of 9
A stainless Kenmore side-by-side with a dispenser on the freezer door, so a water valve and a filter join the list of parts to test.
Sealed-system trouble, from a refrigerant leak to a compressor that will not start, gets fixed in the kitchen as well; the technician on that job is EPA 608 Universal certified, and the fridge stays home.
A white top-freezer refrigerator. If the milk below turns warm while the ice cream up top stays hard, the coil up top has usually iced over or its fan has quit.
A hand runs along the door gasket of an LG washer, feeling for tears and for anything caught in the folds.
A Samsung dryer with steam cycles and a moisture sensor. Long run times on a dryer like this send us to the vent before the heater.
Gray residue and a rust-colored film packed into a washer door boot. That fold holds water, and it is where most front-loader smells begin.
An LG front-loader with the door open and the drum in view. LG is one of the two makers that authorized us, so its warranty repairs come straight to us.
A Frigidaire Professional gas cooktop with all five burners lit: short, even blue cones on every port, which is how a healthy burner looks.
A Maytag front-load dryer. Maytag comes under our Whirlpool authorization, so its covered repairs run through us as well.
The same cooktop with the grates lifted off. The lit burner throws a lopsided flame, a sign to clean the ports and reseat the cap.
- Washington appliance repair license
- Authorized LG and Whirlpool service
- EPA 608 Universal technicians
- Sealed systems repaired on site
- Open seven days, 8 to 7
Ice makers in Mill Creek
What we find on ice maker calls in Mill Creek
In Mill Creek houses the water line to the fridge often comes from a valve in the garage or under the sink, sometimes through a long run of plastic tubing. Old filters and kinked lines are the usual culprits behind thin cubes, and we check them first.
Three conditions make ice: water has to reach the mold, the mold has to dump on schedule, and the freezer must stay cold enough to finish the batch. We trace the water first (valve, tube, pressure), then trigger a harvest on the module and read the freezer temperature, and only then replace what failed.

Ice and water dispenser
1Cubes fused together
A freezer running warm, or a dispenser flap letting in room air.
2Dispenser jams
The auger motor stalls, or cubes have frozen into a block around the auger.
3Drip from the chute
A cracked or frozen fill tube, or a leaking fill valve.
4Undercounter unit quit
A dusty condenser, a failed pump, or a blocked drain.
How it goes
From the first call to a machine that works
- 1
Tell us about it
Call, or fill in the booking card with the machine, its symptoms and your ZIP. Our office rings back to pick an hour that suits you, on any day of the week.
- 2
We test first
The technician checks the outlet or breaker, runs a cycle, and clips a meter onto the parts that match the symptom. Readings, not guesses, decide the diagnosis.
- 3
You approve a written price
You see the repair figure, in ink, before anything comes apart. Go ahead, and the trip charge melts into it; pass, and the trip charge settles it.
- 4
Fixed, with paperwork
Our vans stock the igniters, pumps, valves and fuses that fail most, so plenty of repairs end on visit one. Waiting on an ordered part? The second visit goes on the calendar before we drive off, and your invoice names the warranty period.
Pick a flag
What we fix in Mill Creek
Seven flags on the line, one for each kind of job. Tap one, or let the line run on its own.
Flag 1 of 7
Ice makers
An empty bin, thin cubes, ice packed around the auger.
Mill Creek ice makers page →Around Mill Creek
Where Mill Creek appliances live
Mill Creek is mostly two-story houses from the 1980s through the 2000s, with condos near the town center and newer neighborhoods to the east. Many streets belong to homeowner associations with parking rules, so a note on the request helps.
Questions
Ice makers in Mill Creek: questions
Do you work in Mill Creek neighborhoods with HOA rules?
Yes. Tell us about parking or access rules when we call back, and we will follow them.
Is an LG fridge ice maker under warranty covered through you?
Yes. Because LG has authorized us, a covered ice maker repair is done by us under the warranty.
The ice maker is leaking. Should I switch it off?
Yes, if water is reaching the freezer floor or the kitchen floor. Leave the fridge itself running.
How soon will a repaired ice maker fill the bin?
Give it several hours for the first cubes; the bin usually fills overnight.
Ice Maker Repair in Mill Creek, any day
Give us a sentence about the trouble and your street. Our office rings you to agree on an hour and quote the trip charge; the repair figure follows in writing.







